We stock Alesis NanoVerb and all DJ Equipment from Alesis. We have been selling DJ equipment for over 15 years in our shops, Alesis NanoVerb is just a small part of our extensive range of Studio and Instruments and Signal Processors. If you would like to know more about the Alesis NanoVerb from Alesis, other items of DJ Equipment or about DJ Finance (You can apply here online) please call 0845 8053 054.
Alesis NanoVerb £79.00
Summary
Images (0)
Spec
Reviews (5)
Links (0)
Finance
NanoVerb 18-Bit Digital Effects Processor
Versatile Preset Digital Reverb and Effects
The NanoVerb gives you sixteen of Alesis` best preset effects algorithms in a compact, easy-to-use and incredibly affordable package. You`ll enjoy its lush hall, plate and room reverbs, rich true stereo chorus, flange, delay, rotary speaker emulation and useful multieffects. Plus, NanoVerb`s 18 bit digital converters ensure the sonic quality that allows you to use it for any effects application from guitar rigs to studio recording. The front panel adjust knob allows you to tweak NanoVerb`s great-sounding programs until they`re just right for your music, while the Input/Output levels and Mix controls ensure proper effect levels for a wide variety of applications. Plus, with its amazing low cost, you can afford to put two or three NanoVerbs in your rack for dedicating to multiple sources.
no alternative images available for the Alesis NanoVerb
Specification and product attributes
Frequency Response
40Hz-20kHz, +1/-3dB
Dynamic Range
90dB
Harmonic Distortion
.02% @ 1kHz @ 0dBV
Inputs
Number of Channels- 2, Nominal Level -10dBV, Maximum Level +10dBV, Impedance 1Mohms per channel in stereo
A/D-D/A Conversions
Conversion Scheme- 18 bit Delta Sigma, Processor Speed- 3 Million instructions per second, Processor Memory- 64K x 16 bit, Sampling Frequency- 46.875kHz
Outputs
Number of channels- 2, Matrixed Stereo, Maximum Level +10dBV Impedance 220 ohms
Front Panel
Controls- Input Level, Mix Level, Output Level, Program Selection, Adjust. Indicators- Dual-colored Level LED, Power LED
Rear Panel
Input Left and Right- 1/4, Output Left and Right- 1/4, Power- 5.5mm Barrel Jack
Power
9 VAC, 5 Volt Amps external Transformer, UL and CSA Approved
Dimensions
(WxHxD) 5.5x1.5x4.5
Weight
approx. 1.25 lbs
alan 17/01/2009
YES!
I took this unit out tonight for a noise performance and once I packed up my gear, I stuck the nanoverb in a plastic bag and as I was carrying it, it slipped and dropped HARD on the concrete of the loading dock I played from... I was worried, for sure... I examined it and it looked fine and all the knobs were great, it didn`t e
ven get any chips... I
just tested it and it`s still working great! Thanks, Alesis! This is seriously one of the toughest peices of ge ar I own right now. besides the crackling which has always been a problem with my unit (again, I thin kit`s because I got it used) this thing works without a singal issue... this is about the 5th time I have dropped or banged it, and probably the hardest I`ve done it...
test 17/01/2009
Sound quality[VBCr], x is good to very good. The reverbs are all very true to their type, but some do sound better than other
s. I like to use Hall
2 and 3 alot. I`m guessi
ng the pre-determined decay on the verbs is what seperates one from another. The chorus sounds are very musical. The flanger is fair. There are a couple of combined effects that are ok also. The delay sounds good but you can`t control the feedback which is the number of repeats although you can control the length of the delay time. Each patch has one parameter that can be tweaked. I bought it for the reverbs. I use it in the stereo effect loop of my guitar amp. Adjusting the input is easy, there is a signal overload light that goes from green to red when you overload it. You just need to back the input volume down when that happens. The output knob is a little odd as most units do not use one. I happen to back it down alot because if you run it too hot, it will put unwanted noise into your system. I use it for live playing and it works very well. I like to tweak it as I go along. Its easier than bending over and adjusting a small reverb stomp box with those dumb concentric knobs and tiny little writing that I can`t see.
test 17/01/2009
Sound quality is good to very good. The reverbs are all very true to their type, but some do sound better than others. I like to use Hall 2 and 3 alot. I`m guessing the pre-determined decay on the verbs is what seperates one from another. The chorus sounds are very musical. The flanger is fair. There are a couple of combined effects that are ok also. The delay sounds good but you can`t control the feedback which is the number of repeats although you can control the length of the delay time. Each patch has one parameter that can be tweaked. I bought it for the reverbs. I use it in the stereo effect loop of my guitar amp. Adjusting the input is easy, there is a signal overload light that goes from green to red when you overload it. You just need to back the input volume down when that happens. The output knob is a little odd as most units do not use one. I happen to back it down alot because if you run it too hot, it will put unwanted noise into your system. I use it for live playing and it works very well. I like to tweak it as I go along. Its easier than bending over and adjusting a small reverb stomp box with those dumb concentric knobs and tiny little writing that I can`t see.
alan 17/01/2009
This unit is too... easy to use and you can finely adjust the sound to suit your needs. I got this about three months ago and I didn`t even need to read the manual! If you know what sound you want (and like) then that`s all you need - let your ears do the tuning! The drummer in the band wanted to test it out on his Electric Drum Kit. He now WANTS ONE for the simple reason that it is EASIER and QUICKER to turn a knob than to scroll through a piddly LCD screen on stage adjusting Reverbs!
alan 17/01/2009
YES!
I took this unit out tonight for a noise performance and once I packed up my gear, I stuck the nanoverb in a plastic bag and as I was carrying it, it slipped and dropped HARD on the concrete of the loading dock I played from... I was worried, for sure... I examined it and it looked fine and all the knobs were great, it didn`t e
ven get any chips... I
just tested it and it`s still working great! Thanks, Alesis! This is seriously one of the toughest peices of ge ar I own right now. besides the crackling which has always been a problem with my unit (again, I thin kit`s because I got it used) this thing works without a singal issue... this is about the 5th time I have dropped or banged it, and probably the hardest I`ve done it...
Finance is offered* on selected products and/or on purchases of a certain total value.
More information on ++expected monthly payments can be found in your shopping cart.
*finance is subject to status. ++ all figures quoted are estimations and subject to change, figures may also change according to your curcumstances and the finance company that we use.
0 items. 
